4 Configuration/Engineering
EtherNet/IP Scanner
Entry-ID: 109782314, V1.1.0, 04/2021
© Siemens AG
2021 All rights reserved
4 Configuration/Engineering
4.1 Creating and managing projects
To follow along with this application example the TIA Portal project should have
been downloaded from SIOS.
A new TIA Portal project may also be created as it allows to adopt the hardware
platform accordingly.
However, it is not part of this document to explain the setup of the hardware
being used as EtherNet/IP Scanner.
Table 4-1: Configuration instructions
Retrieve the downloaded TIA Portal
project
(EnetScanner.zap15_1)
This will extract the compressed TIA
Portal archive into a folder of your
selection.
Open the contained SIMATIC S7-1500
controller
You will see the function block
LCCF_EnetScanner in the program
folder as well as two data blocks.
• EnetIoSystem
• InstScanner
You will also see a Cyclic Interrupt OB.
To Next Page
Loading...
