Siemens S7-1200 - Page 103

Programming the program blocks
5.4 IF_CONF: SDT for the configuration data of the CP
CP 1243-7 LTE
Operating Instructions, 01/2015, C79000-G8976-C381-01
103
"PIN"
In STEP 7, the PIN can be found in the parameter area "Mobile wireless communications
settings" > "Services and settings".
Table 5- 7 IF_CONF_PIN
Parameter
Data type
Initial value
Description
Id
UINT
11
ID of the parameter field
Length UINT Length of the parameter field in bytes: 16
Mode
UINT
Validity (1, 2) - see above (general parameters)
Pin STRING [8] PIN of the SIM card inserted in the SIM card
The parameter is not relevant if the PIN was correctly
configured. If the PIN was incorrectly configured, the
correct PIN can be entered.
"Authorized phone number"
In STEP 7, the corresponding data is located in the "Security" parameter area.
Table 5- 8 IF_CONF_WakeupList
Parameter
Data type
Initial value
Description
Id
UINT
13
ID of the parameter field
Length
UINT
Length of the parameter field in bytes: 246
Mode
UINT
Validity (1, 2) - see above (general parameters)
WakeupPhone [1...10] ARRAY [1...10]
of STRING [22]
Phone number subscriber authorized to wake up
The asterisk (*) at the end of a call number is used a
placeholder for direct dialing numbers.