Accessories
4.3 Connection system
3VA molded case circuit breakers with UL and IEC certification
Manual, 01/2019, L1V30435333-01
189
Distribution wire connector, 6 cables
The distribution wire connector, 6 cables, is an external terminal that projects beyond the
molded case circuit breaker contour of the termination area. It can hold up to 6 cables. One
of the six holes in the terminal can be used to implement a control wire tap.
For all distribution wire connectors, 6 cables, the extended terminal cover and the required
installation materials are included in the scope of delivery. This is used for insulation and
provides degree of protection IP4x at the front of the molded case circuit breaker and degree
of protection IP2x at the infeed side and load side (see chapter Insulating equipment
(Page 203)).
The following table shows all the possible cable connections of the distribution wire
connector, 6 cables.
3VA5 molded case circuit breakers:
To Next Page
Loading...
