Accessories
4.3 Connection system
3VA molded case circuit breakers with UL and IEC certification
206 Manual, 01/2019, L1V30435333-01
The terminal cover is compatible with:
● Box terminals
● Wire connectors
● Nut keeper kits
The terminal cover is simply snapped into place on the 3VA UL molded case circuit breaker
(3VA5 125 A) or snapped into place and secured with 2 screws (3VA5 250 A and 3VA6).
Rear insulating plate, provides insulation from the panel mounting plate
Front half, pushed over the molded case circuit breaker from the front
The insulating plate is fitted to the rear panel of the molded case circuit breaker and then
secured by 2 screws to the front half of the terminal cover. The terminal cover extended is
also secured by 2 additional screws to the molded case circuit breaker itself.
The terminal cover extended is compatible with:
● Wire connectors, large (terminal cover extended included in scope of supply)
● Wire connectors, 2 cables (terminal cover extended included in scope of supply)
● Distribution wire connector, 6 cables (terminal cover extended included in scope of
supply)
● Front bus connectors extended
To Next Page
Loading...
