04/99 Introduction
Getting Started with C7-621-AS-i 7
Checklist for startup
The following basic steps are necessary for starting up the SIMATIC C7-621-AS-i:
Þ Install STEP 7 or STEP 7-Mini on PC/programming device
Þ Install ProTool or ProTool/Lite integrated under STEP 7 or STEP 7-Mini on PC/programming device
Þ Connect C7 to power supply (+24V)
Þ Connect power pack to C7-AS-i port
Þ Set up AS-i network
Þ Set addresses of slaves and parameterize C7-AS-i-CP
Þ Select STEP 7-Mini on programming device/PC and create PLC program
Þ Connect C7 ↔ PC/programming device via PC/MPI cable
Þ Overall reset of C7-CPU and C7-OP
Þ Transfer PLC program to C7
Þ Select ProTool/Lite on programming device/PC and create OP configuration
Þ Transfer configuration to C7
To Next Page
Loading...
