Siemens simatic ET 200MP - Address Space of AI 8 xU;I;R;RTD BA

Parameters/address space
4.4 Address space
Analog Input Module AI 8xU/I/R/RTD BA (6ES7531-7QF00-0AB0)
Manual, 03/2019, A5E44792324-AA
25
4.4 Address space
The module can be configured differently in STEP 7; see following table. Depending on the
configuration, additional/different addresses are assigned in the process image of the inputs.
Configuration options of AI 8xU/I/R/RTD BA
You can configure the module with STEP 7 (TIA Portal) or with a GSD file.
When you configure the module by means of the GSD file, the configurations are available
under different abbreviations/module names.
The following configurations are possible:
Table 4- 3 Configuration options
Configuration
Short designation/
module name in the
GSD file
Configuration software, e.g., with STEP 7 (TIA Portal)
Integrate in the hardware
catalog STEP 7 (TIA Portal)
as of V15.1 and HSP 0275 or
V16
GSD file in
STEP 7 (TIA Portal) V12
or higher or STEP 7 V5.5
SP3 or higher
1 x 8-channel without value status
AI 8xU/I/R/RTD BA
X
X
1 x 8-channel with value status
AI 8xU/I/R/RTD BA QI
X
X
8 x 1-channel without value status AI 8xU/I/R/RTD BA S X
(PROFINET IO only)
X
(PROFINET IO only)
8 x 1-channel with value status AI 8xU/I/R/RTD BA S
QI
X
(PROFINET IO only)
X
(PROFINET IO only)
1 x 8-channel with value status for
module-internal shared input with up
to 4 submodules
AI 8xU/I/R/RTD BA MSI X
(PROFINET IO only)
X
(PROFINET IO only)
Value status (Quality Information, QI)
The value status is always activated for the following module names:
● AI 8xU/I/R/RTD BA QI
● AI 8xU/I/R/RTD BA S QI
● AI 8xU/I/R/RTD BA MSI
An additional bit is assigned to each channel for the value status. The value status bit
indicates if the read in digital value is valid. (0 = value is incorrect).