2-1
FM 456-2 Application Function Module Installation, Hardware, and Startup
C79000-G7076-C458-01
Installation and Startup
This section provides you with some brief information about the necessary steps to
start up an FM 456-2.
The startup activities can be divided into several steps, which should be carried out
in the order shown:
1. Installing and switching on the hardware
2. Load operating system, adapt BIOS setup if necessary
3. Load user software into the FM 456-2 from PG/PC, test and commission. Adapt
S7/M7 software to the FM 456-2 functions.
The activities you must carry out in step 1 of the startup process are shown below
in the correct order in form of a checklist. The checklist contains notes on where
you can find detailed information on each point.
Refer to
manuals /2/ and /3/
for information on activities in steps 2 and 3 of the
startup process.
In this Chapter
Section Subject Page
2.1 Installation Checklist and Switch-on Test 2-2
2.2 Module Accessories 2-3
2.3 Installing Interface Submodules 2-4
2.4 Installing a Short AT Card 2-6
2.5 Fitting Expansion Modules to an FM 456-2 2-8
2.6 Installing a Module Assembly in the Module Rack 2-14
2.7 Inserting/Removing the Memory Card 2-18
2.8 Connecting a Module Assembly 2-19
2.9 Preparing for Operation 2-20
2.10 Connecting the Operator Panels and Peripherals 2-21
2.11 Connecting a Programming Device or PC to the COM Interface 2-23
2.12 First Switch-On of the FM 456-2 2-26
2
To Next Page
Loading...
