Commissioning the device
4.3 Parameter assignment for Comfort Panel
Comfort Panels
Operating Instructions, 07/2017, A5E36770603-AB
129
You can use this option to configure the Sm@rtServer for the HMI device. You can then
access the HMI device using a Web browser, the Sm@rtClient app or other Java-based
clients. Operator control and monitoring of the HMI device is possible, depending on the
parameter assignment of the Sm@rtServer.
● For HMI devices with an image that is compatible with WinCC (TIA Portal) prior to V14,
the following applies: The HMI device has a Sm@rt Server license that was transferred to
the HMI device via the Automation License Manager. Starting with WinCC (TIA Portal)
V14, the Sm@tServer option for Comfort Panels is license-free.
● The HMI device has a project that was compiled with option "Runtime settings > Services
> Remote control > Start Sm@rtServer".
● The Control Panel is open.
● Your system administrator has provided you with the necessary information for parameter
assignment of the Sm@rtServer.
Note
The "Remote" tab is only available if the HMI device has a project that was created with the
"Start Sm@rtServer" option.
Additional tabs may appear in the "WinCC
Internet Settings" dialog. This depends on the
options that have been enabled for operating the local network in the project.
1. Open the "WinCC Internet Settings" dialog using the "WinCC Internet Settings" icon.
2. Change to the "Remote" tab.
To Next Page
Loading...
