Commissioning the device
4.3 Parameter assignment for Comfort Panel
Comfort Panels
Operating Instructions, 07/2017, A5E36770603-AB
77
Using the HMI device in password-protected security mode
If security mode has been activated, only the "Transfer" and "Start" buttons can be operated
without a password. To deactivate security mode, delete the password as described in
"Changing password protection (Page 93)".
● A password has been assigned as described in "Changing password protection
(Page 93)".
● The security mode is displayed, similar to the figure below:
1. Operate a password-protected desktop icon, the taskbar or the "Settings" or "Taskbar"
button in the Start Center.
The following dialog appears:
2. Enter the required password.
3. Confirm your entry with "OK".
The dialog will close and the selected operator control open.
To Next Page
Loading...
