D-3
Operator Panel OP3
Edition 11/99
D.5 Shipping ESDs
As a matter of policy, modules and components should be stored and shipped
only in conductive packing – for example, metalized plastic boxes, tin cans.
Should packing not be conductive, modules must be conductively wrapped
before they are packed. You can use, for example, conductive foam rubber,
ESD bags, domestic aluminum foil and paper (under no circumstances should
you use plastic bags or foils).
With modules containing fitted batteries, make sure that the conductive
packing does not come into contact with or short-circuit battery connections;
if necessary, cover battery connections beforehand with insulating tape or
insulating material.
Conductive
packing
Protecting/covering
batteryconnections
ESD Guidelines
To Next Page
Loading...
