3-3
Operator Panel OP3
Edition 11/99
In combination with SHIFT:
SHIFT
+ : Scroll up in font.
SHIFT
+ : Scroll down in font.
SHIFT
+ : Next position in an input field.
SHIFT
+ : Previous position in an input field.
The numeric and arrow keys have a auto repeat function. If you keep a key
pressed, your input is continually repeated after a short delay until you
release the key.
If several keys are pressed in quick succession, some operator inputs may be
lost. Operator inputs not accepted by the OP3 are indicated by an acoustic
signal.
3.1.1 SHIFT for Digits and Soft Keys
Depending on the configuration, you can set whether you want to assign
SHIFT to digits or soft keys. You perform the setting in ProTool by choosing:
System → Settings from the menu.
Example:
If you frequently change between screens, it is practical to assign SHIFT not
to soft keys but to digits. For inputs, you then press SHIFT and the
corresponding numeric key.
Operation Notes
SHIFT
General Operation
To Next Page
Loading...
