B-7
Equipment
Manual OP7, OP17
Release 04/99
Remedy:CauseMes-
sage
338 OP
can not establish a connection with the prin
-
ter.
1.
Printer is not switched on,
2.
Printer is not ready
,
3.
Connecting lead between printer
<––> OP is not connected or defec
-
tive,
4. No interface module inserted.
339
Startup completed.
Communication with PLC has been
resumed.
340
Status processing in progress on PU/PC. The OP
can not be used while this is going on.
341
Internal err
or
W
ith non-Siemens connections: data block error
342
Network node has illegal address.
Max. addresses:
S7-MPI: 32
PROFIBUS-DP: 128
353
The minimum value is greater than the maximum
value for variable scales.
Minimum and maximum values are
being confused by OP
. T
o prevent
this, enter correct minimum and ma
-
ximum values.
359
The CPU is in ST
OP mode.
System error message issued if S7
messages are not available.
366 –
The mode you require is already active.
–
The CPU key-operated switch is not set to
RUN-P.
–
The command is not supported by the CPU.
367
Set PLC parameters are incorrect.
368
Communication error S7 module; error class and
error number will be read out.
369
The command cannot be executed in the S7 mode
selected.
392 –
No alarm messages are queued on the NC.
–
Acknowledgement is not possible in the NC
mode set.
393
The password is incorrect or you cannot enter a
password in the NC mode set.
394
Acknowledgement is not possible on the NC set.
395 –
No part programs have been configured.
–
The PLC specified (FM or NC) is not ready
.
396 –
The part program specified does not exist.
–
The PLC specified (FM or NC) is not ready; in
the case of FM: no user data area has been created
on the PLC.
To Next Page
Loading...
Need help?
General
