Siemens simatic hmi op7 User Manual

B-13
Equipment Manual OP7, OP17
Release 04/99
Remedy:CauseMes-
sage
637 Missing configuration for an event message
Configure event message (–> message
b) fll
638,
639
Actual value field for event message has only
been created symbolically .
g g( g
number) fully .
640 Alarm message is not configured
Configure alarm message (–> mes -
b)
641 Alarm message triggered is not configured
gg(
sage number).
642,
643
The actual value field for alarm message has only
been created symbolically .
Reconfigure alarm message (–> mes -
sage number).
645 Internal err or
PLC co-ordination area not receivable during
startup.
Press key to restart.
If the fault is not corrected by perfor -
ming a restart, please contact the SI -
MA
TIC Hotline.
648 The driver number configured can not be inter -
preted.
649 Internal err or
Driver number configured can not be interpreted.
If the fault is not corrected by perfor -
ming a restart, please contact the SI -
MA
TIC Hotline.
650 Missing area pointer . Configure an area pointer .
651 Internal err or
There is not at least one data record for every re -
cipe.
If the fault is not corrected by perfor -
ming a restart, please contact the SI -
MA
TIC Hotline.
652 Configuration is not compatible with S5 Change configuration and retransfer .
If the fault is not corrected by perfor -
ming a restart, please contact the SI -
MA
TIC Hotline.
653 The configured user version number does not
match the version number stored on the PLC.
Change configuration and retransfer .
654 The PLC acknowledgement area has not been
configured to follow on physically from the mes -
sage area.
655 PLC acknowledgement area does not physically
follow on from the alarm messages area (–> no
startup).
656 Configured protocol is not possible. Check protocol in configuration.
657 Configured PLC protocol is not possible. Use current firmware version or con -
figure dif ferent protocol.
658 Configured PLC protocol is not possible.
659 Illegal process link in recipe, destination does not
exist.
Change configuration and retransfer .
660 Invalid destination configured for return reference
in menu.
Break key on OP; complete configu -
ration and retransfer

Siemens simatic hmi op7 Specifications

General

Brand	Siemens
Model	simatic hmi op7
Category	Control Panel
Language	English