IM151-1 HIGH FEATURE interface module (6ES7151-1BA02-0AB0)
Manual, 03/2008, A5E01075975-02
5
Table of contents
Preface ......................................................................................................................................................
3
1 Properties ..................................................................................................................................................
7
1.1 IM151-1 HIGH FEATURE interface module (6ES7151-1BA02-0AB0)..........................................
7
2 Parameters..............................................................................................................................................
13
2.1 Parameters for the IM151-1 HIGH FEATURE interface module .................................................
13
2.2 Parameter description..................................................................................................................
14
2.2.1 DP interrupt mode........................................................................................................................
14
2.2.2 Bus length ....................................................................................................................................
14
2.2.3 Enable startup for set <> actual configuration .............................................................................
14
2.2.4 Option handling in general...........................................................................................................
14
2.2.5 Option handling: Slot 2 to 63........................................................................................................
15
2.2.6 Diagnostic interrupt ......................................................................................................................
15
2.2.7 Process interrupt..........................................................................................................................
15
2.2.8 Insert/remove-module interrupt....................................................................................................
15
2.2.9 Analog-value format.....................................................................................................................
15
2.2.10 Interference frequency suppression ............................................................................................
16
2.2.11 Reference junction slot ................................................................................................................
16
2.2.12 Reference junction input ..............................................................................................................
16
2.2.13 Synchronize DP slave with equidistant DP cycle.........................................................................
16
2.2.14 Time Ti (read in process values)..................................................................................................
17
2.2.15 Time To (output process values) .................................................................................................
17
3 Functions.................................................................................................................................................
19
3.1 Cycle synchronization..................................................................................................................
19
3.1.1 Basics...........................................................................................................................................
19
3.1.2 Assigning the parameters for cycle Synchronization on the PROFIBUS DP ..............................
22
3.1.3 Troubleshooting during isochronous mode on PROFIBUS DP...................................................
25
3.2 Option handling with RESERVE modules ...................................................................................
26
3.2.1 Principle of operation of option handling with RESERVE modules .............................................
26
3.2.2 Prerequisites for option handling with RESERVE modules.........................................................
27
3.2.3 Example for using RESERVE modules .......................................................................................
28
3.2.4 Assigning parameters for option handling with RESERVE modules...........................................
29
3.2.5 Controlling and monitoring options with RESERVE modules......................................................
30
3.2.6 Troubleshooting for option handling with RESERVE modules....................................................
32
3.2.7 Address area for option handling and status byte with RESERVE modules...............................
32
3.3 Option handling without RESERVE modules ..............................................................................
34
3.3.1 Principle of operation of option handling without RESERVE modules ........................................
34
3.3.2 Prerequisites for option handling without RESERVE modules....................................................
35
3.3.3 Example for use without RESERVE modules..............................................................................
36
3.3.4 Configuring option handling without RESERVE modules............................................................
37
3.3.5 Controlling and monitoring options without RESERVE modules.................................................
38
3.4 Identification data.........................................................................................................................
40
To Next Page
Loading...
Need help?
General
