Siemens SIMATIC IPC BX-39A - Danger of burns; ESD directive

Configure firmware
2.4 "Advanced" tab
Firmware/BIOS description SIMATIC IPC BX-39A, IPC PX-39A, IPC PX-39A PRO
20 Operating Instructions, 01/2023, A5E51110693-AA
2.4.5 "System Agent (SA) Configuration"
2.4.5.1 "Graphics Configuration"
Note
Depending on the device type and the device configuration, the "Graphics Configuration"
submenu may not be visible.
Calling "Graphics Configuration"
Select: "Setup Utility (Page 10)" > "Advanced" > "System Agent (SA) Configuration" >
"Graphics Configuration".
Firmware setting Value Setting in deliv-
ery state
Meaning
IPC BX-39A
IPC PX-39A
IPC PX-39A PRO
Primary Display
Auto
x
During the boot procedure, the system automatically detects
whether the device has a graphics card. Messages during the
boot procedure are then issued via the graphics card. If no
graphics card is present, messages during the boot process
are output via the integrated onboard graphics interface
(Internal Graphics Device = IGFX).
IGFX
Messages during the boot process are preferably output via
the integrated onboard graphics interface (Internal Graphics
Device = IGFX). (if the onboard graphics interface is disabled,
messages during the boot process can also be output on a
graphics card, if present.)
Internal Graphics
Auto
The integrated onboard graphics interface (Internal Graphics
Device = IGFX) is disabled if an external graphic is detected.
Disabled
The integrated onboard graphics interface (Internal Graphics
Device = IGFX) is disabled.
Enabled
x
The integrated onboard graphics interface (Internal Graphics
Device = IGFX) is enabled.