BIOS Setup (SCU)
3.4 Advanced menu
BIOS Description
Operating Manual, 05/2016, A5E33664825-AB
25
Per-Port Control The USB ports cannot be individually disabled (Disabled): All ports are
enabled by default.
If Per-Port Control is enable (Enabled), the list of USB ports is shown:
Individual ports cannot be separately enabled or disabled. The enable
status of all ports is saved and appears each time if Per-Port Control is
The following Setup parameters depend on the hardware configuration of your device and are visible
if "Per-Port Control" is enabled:
• USB Port 0
Enable (Enabled) or disable (Disabled) USB port.
Applies only to IPC277E: USB Port 2 is visible depending on the ordered
device configuration. If USB Port 2 (USB hub) is disabled, Port 5
(Front/MutliTouch), Port 6 (Single Touch) and Port 7 (Internal) are
disabled.
• USB Port 1
• USB Port 2
• USB Port 3
• USB Port 4
• USB Port 5
• USB Port 6
• USB Port 7
• USB Port 8
• USB Port 9
• USB Port 10
3
• USB Port 11
3
Only with Field programming device
3
Only with IPC647 and IPC847
"Chipset Configuration (Miscellaneous)" submenu
To Next Page
Loading...
Need help?
General
