2-2
OEM
Push Button Panel Equipment Manual
Release 08/98
The
system settings for the PROFIBUS-DP connections are:
DP slave address:
3
Baud rate:
1500 KBaud
The following table provides an overview of the possibilities for modifying the
defined system settings:
Intention Procedure Chap-
ters
Set connection type DP Set connection type DP on the
Push Button Panel
2.1
Change DP slave address
Change the DP slave address
on the Push Button Panel
2.1
Change baud rate Change baud rate on Push
Button Panel
2.1
Configure Push Button Panel
properties which deviate from
Set parameter in the configu-
2.3
properties which deviate from
pre-adjusted system settings
ration software
PROFIBUS-DP
connection
Starting Up the Push Button Panel
To Next Page
Loading...
