Siemens SIMATIC OEM PP32 - Page 67

Index-1
OEM Push Button Panel Equipment Manual
Release 08/98
Index
A
Ambient conditions, A-1
Assignment, Control bit, 3-1
Assignment, interface, A-4
Attach labeling strips, 7-1
B
Barometric pressure, A-2
Baud rate, 1-5, 2-1, 2-2, 2-5
Bits, PLC, 3-1
Bouncing time, A-3
Burst interference, A-2
Bus connection, A-4
C
Cable, 4-4
Cable length, maximum, A-3, A-4
Checksum, C-2
COM–PROFIBUS, 2-5, 2-6, 2-7, 2-12
Communication, 1-5
Conduction, RF, A-2
Configuration, 1-3
Interface to PLC, 2-3
Keys, 2-9, 2-11, 2-12
LEDs, 2-9, 2-11, 2-12
PLC, 2-6
Configuration mode, 2-3
Configure Interface, 2-3
Configure Keys, 2-9
Configure LEDs, 2-9
Configuring data block, 2-1, 2-5, 2-6, 2-11, B-2
Configuring keys, 2-11, 2-12
Configuring LEDs, 2-11, 2-12
Connect
Additional elements, 4-4
Ground, 4-4
Connectable elements, A-2
Connection type, 2-1, 2-2
MPI, 2-1, 2-5, 2-6, 2-11, 2-13
PROFIBUS–DP, 2-2, 2-5, 2-6, 2-12
Connection types, 1-3
Contact discharge, A-2
Control bit, Assignment, 3-1
Coordination, PLC and Push Button Panel, 2-13
D
Data, technical, A-1
Data area, 2-1, 2-5
Data block, 2-5, 2-6, 2-11
Data transmission, Baud rate, 1-5
Data word, 2-5
Degree of protection, 4-1, A-1
Delay, A-3
Digital inputs, A-2, C-2
Function, 2-10
Numeration, 3-2
Digital outputs, A-3, C-2
Function, 2-10
Numeration, 3-1
Discharge, static, A-2
Display, Messages, B-2
DP slave address, 2-2, 2-5
E
EMV, 4-3
Error LED, Signals, B-1
Error messages, B-2
External dimensions, A-1
F
Front view
OEM PP32, 5-1
OEM PP32/OP17, 6-1
Function keys, 2-9
Function of digital outputs, 2-10
Fuse, internal, A-1
G
Grounding connection, 4-4