Siemens Simatic S7-1500

Configuring a software controller
3.10 Parameter view
PID control
58 Function Manual, 03/2017, A5E35300227-AC
3.10.5.2
Filtering the parameter table
You can filter the parameters in the parameter table in the following ways:
● With the text filter
● With the subgroups of the navigation
Both filter methods can be used simultaneously.
With the text filter
Texts that are visible in the parameter table can be filtered. This means only texts in
displayed parameter rows and columns can be filtered.
1. Enter the desired character string for filtering in the “Text filter...” input box.
The parameter table displays only the parameters containing the character string.
The text filtering is reset.
● When another parameter group is selected in the navigation.
● When navigation is changed from data navigation to functional navigation, or vice versa.
With the subgroups of the navigation
1. Click the desired parameter group in the navigation, e.g., "Static".
The parameter table only shows the static parameters. You can select further subgroups
for some groups of the navigation.
2. Click “All parameters” in the navigation if all parameters are to be shown again.