Siemens Simatic S7-300 - Preparing the Connection to the SINAMICS; Overview; Creating a STEP 7 Project

Commissioning
3.3 Preparing the connection to the SINAMICS
Connection of the SINAMICS S120 to the Technology CPU
Product Information, 09/2011, A5E00480378-04
23
3.3 Preparing the connection to the SINAMICS
3.3.1 Overview
Introduction
To establish a connection for the configuring of the SINAMICS S120 between the
programming device and the drive system, several preliminary tasks must be performed;
these tasks are discussed in detail in the following sections.
3.3.2 Creating a STEP 7 project
Procedure
To create a new project, start the SIMATIC Manager and use the File > New menu
command to create a new project, for example, a project with the name DSC_SINAMICS.
Then use the Insert > Station > SIMATIC 300 station menu command to add a new
S7 300 station.