Comfort Panels INOX PCT
20 Compact Operating Instructions, 07/2021, A5E38804191-AE
Installing and connecting the device
3.1 Preparing for installation
3.1.1 Check the scope of delivery
Check the scope of delivery for visible signs of damages caused during transport and for
completeness, see chapter "Scope of delivery (Page 8)".
Damaged parts
A damaged part can cause device malfunctions.
Do not install damaged parts.
In the case of damaged parts or incomplete delivery, contact your Siemens representative.
3.1.2 Checking the operating conditions
Note the following aspects before installing the device:
1. Familiarize yourself with the standards, approvals, EMC parameters and technical
specifications for operation of the device. This information is available in the following
chapters:
– Certificates and approvals (Page 36)
– Electromagnetic compatibility (Page 39)
2. Check the mechanical and climatic ambient conditions for operation of the device; see
Technical specifications (Page 36).
3. Follow the notes on use in the operating instructions.
3.1.3 Permitted mounting positions
The HMI device is suitable for installation in:
• Control cabinets
• Switchboards
• Consoles
In the following, all of these mounting options are referred to by the general term "cabinet".
The HMI device is self-ventilated and approved for inclined mounting at angles of up to +/-35°
in stationary cabinets.
To Next Page
Loading...
