Siemens SIMATIC USB-Prommer - Connecting to the PC

USB-Prommer
Commissioning Manual, 04/2020, A5E50041544-AA
9
Connecting to the PC
4
1. Insert the supplied USB cable into a USB port on your PC.
2. Insert the other end of the USB cable into the USB port of the SIMATIC USB-Prommer.
3. During initial operation of the SIMATIC USB-Prommer, you must set the programming
interface to "External prommer" at the "USB" port in the Control Panel with the "Memory
Card Parameter Assignment" panel.
When you select the setting "Detect USB prommer automatically", the connection of the
SIMATIC USB-Prommer to the PC is detected automatically.
NOTICE
USB cable
Connect the SIMATIC USB-Prommer to the PC only with the supplied USB cable.