Preface
ix
Siemens AG, 2004. All rights reserved
Induction Motors, 1PH7 (APH7S) – 05.04 Edition
Caution
Motors should be connected-up according to the circuit diagram provided. They
must not be connected directly to the three-phase supply because this will
damage them.
SIMODRIVE drive units with induction motors are subject, as part of the routine
test, to a voltage test in accordance with EN 50178. While the electrical
equipment of industrial machines is being subject to a voltage test in
accordance with EN60204-1, Section 19.4, all SIMODRIVE drive unit
connections must be disconnected/withdrawn in order to avoid damaging the
SIMODRIVE drive units.
Notes
SIMODRIVE units with induction motors fulfill, when operational and in dry
operating rooms, the Low-Voltage Directive 73/23/EEC.
SIMODRIVE units with induction motors fulfill, in the configuration specified in
the associated EC Declaration of Conformity, the EMC Directive 89/336/EEC.
To Next Page
Loading...
