Siemens SIMODRIVE 611-D - Page 142

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–134
SINUMERIK 840C / SIMODRIVE 611–D (DA)
144104 ”Wrong selection G02/03 !”
144105 ”Block sequence wrong !”
144106 ”Values for contour definition faulty !”
144108 ”Wrong axis programmmed for cont. definition!”
144109 ”Target position cannot be reached !”
144150 ”Scale modification not allowed !”
144151 ”Illegal scale value !”
144152 ”Coordinate rotation not allowed !”
144200 ”Smooth appr. + retraction cannot be selected!”
144201 ”Not poss. to deselect smooth appr. + retr. !”
144202 ”Wrong smooth approach and retraction plane !”
144203 ”No TRC chosen on selecting smooth app.+retr.!”
144204 ”No added axis with smooth appr. + retr. !”
144205 ”Select/deselect TRC not possible !”
144206 ”Contour violation TRC !”
144207 ”Too many blocks programmed without path !”
144208 ”No equidistant intersection available!”
144209 ”Transform. not allowed with active TRC !”
144210 ”No axis added with TRC !”
144211 ”No added axis with TLC !”
144300 ”Transmit grouping %1 in channel %2 illegal !”
144301 ”Current transformation not deselected !”
144302 ”Transformation type %1 not defined”
144304 ”Axis %1 cannot be traversed with TRANSMIT !”
144305 ”Feed is zero !”
144309 ”Circle end point error in interpolation !”
144311 ”G4 S progr., spindle not rotating !”
144312 ”G96 S progr., leading spindle missing!”
144313 ”Velocity limitation”
144316 ”Rotary axis feed G98: G1 or G36 required !”
144318 ”Path thru transformation centre not allowed”
144319 ”Veloc. of transmit rotary axis too high”
144320 ”Veloc. of transmit linear axis too high”
144350 ”Axis %1 not possible. Only 3 axes at present”
144351 ”Axis %2 not permitted in channel %1!”
144352 ”Axis %2 disabled in channel %3!”
1 Alarms
1.5.1 Alarm description