Siemens SIMODRIVE 611-D - Page 149

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–141
SINUMERIK 840C / SIMODRIVE 611–D (DA)
146310 ”Context: G15 block expected”
146311 ”Context: G220–G222 block expected”
146312 ”Context: G420–G426 block expected”
146320 ”Conflict: measuring function @720 not allowed”
146321 ”Conflict: G function of 7th group not allowed”
146322 ”Conflict: scale modification not allowed”
146323 ”Conflict: synchr. spindle stop not allowed”
146324 ”Conflict: jump not allowed but still performed”
146326 ”Conflict: dwell not allowed”
146327 ”Conflict: ref.pt preprocessing not allowed”
146328 ”Conflict: intersection calc. not allowed”
146329 ”Conflict: plane selection not allowed”
146330 ”Conflict: cylindr. interpolation not allowed”
146331 ”Conflict: transformation not allowed”
146332 ”Conflict: ref. point approach not allowed”
146333 ”Conflict: pole selection not allowed”
146335 ”Conflict: @714 not allowed”
146337 ”Conflict: G200 block not allowed”
146340 ”Conflict: G15 block invalid”
146341 ”Conflict: G200–G222 block invalid”
146342 ”Conflict: G420–G426 block invalid”
146400 ”G%1: more than 1 radius in block”
146401 ”G%1: radius is missing –> value 0 added”
146402 ”G%1 ignored because of soft approach/retract.”
146403 ”G%1: plane axis is missing in block”
146404 ”G48 prog. w/o previous approach / distance 0”
146405 ”G%1: radius 0 programmed”
146406 ”G%1: amount formed for negative radius”
146407 ”G%1: allowed with G0/G1/G2/G3 only”
146410 ”G%1: interpolation parameter is missing”
146411 ”G%1:several thread leads prog. –>1st is valid”
146412 ”G%1: thread lead param. does not match axes”
146415 ”G%1: 1 axis or 2 axes are expected”
146416 ”G%1: thread lead must be positive”
146417 ”G%1: no axis programmed”
146418 ”G%1: thread lead change F is missing”
1 Alarms
1.5.1 Alarm description