04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–181
SINUMERIK 840C / SIMODRIVE 611–D (DA)
Digital drives configured although there is
no DCM (drive bus interface) on the NC
hardware
Illegal internal ramp-up status
Replace NC hardware
Reinstall NC system software
Contact service
Replace NC hardware
Reinstall NC system software
Contact service
Replace NC hardware
Reinstall NC system software
Contact service
invalid status var_meldung()
Replace NC hardware
Reinstall NC system software
Contact service
invalid status send_msg()
– no message buffer free
– error with smtk_send()
Replace NC hardware
Reinstall NC system software
Contact service
invalid status mk_tea30_check()
(error during interpretation of drive configu-
ration)
Delete drive configuration
Reinstall NC system software
Contact service
invalid status mk_bus_init()
Replace hardware:
control module 611D,
NC module
Contact service
Invalid status zustand_antrieb()
Default status–0
Replace hardware:
control module 611D,
NC module
Invalid status zustand_antrieb()
Acknowledgement status–0
Replace hardware:
control module 611D,
NC module
Invalid status zustand_antrieb()
Default status–1
Replace hardware:
control module 611D,
NC module
Invalid status zustand_antrieb()
Acknowledgement status–1
Replace hardware:
control module 611D,
NC module
Invalid status zustand_antrieb()
Default status–2
Replace hardware:
control module 611D,
NC module
Invalid status zustand_antrieb()
Acknowledgement status–2
Replace hardware:
control module 611D,
NC module
Invalid status zustand_antrieb()
Default status–3
Replace hardware:
control module 611D,
NC module
Invalid status zustand_antrieb()
Acknowledgement status–3
Replace hardware:
control module 611D,
NC module
Invalid status zustand_antrieb()
Default status–4
Replace hardware:
control module 611D,
NC module
Invalid status zustand_antrieb()
Acknowledgement status–4
Replace hardware:
control module 611D,
NC module
Invalid status zustand_antrieb()
Acknowledgement status–5
Replace hardware:
control module 611D,
NC module
Invalid status
anstoss_hintergrund()
Replace hardware:
control module 611D,
NC module
Invalid status
lese_alarm_status()
Replace hardware:
control module 611D,
NC module
Invalid status
with drive alarm processing
(al_status)
Replace hardware:
control module 611D,
NC module
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
Need help?
General
