1FT6 Synchronous Motors
Configuration Manual, (PFT6), 10.2005 Edition, 6SN1197-0AD02-0BP1
1-9
Motor Description
Technical data
1) With absolute encoder (due to the max. encoder temperature)
2) Power connector and terminal box mutually exclude each other
3) Motor with terminal box, max. cross-section that can be connected, refer to Table "Connections for terminal boxes"
4) The shock hazard protection of the power cables depends on the size of the selected power module (refer to the
Configuration Manual, Drive Converters)
5) Motor with terminal box, power and signal cables, refer to Catalog, Chapter "MOTION-CONNECT connection sys-
tem"
6) 6FX8002 = MOTION-CONNECT 800;
6FX5002 = MOTION-CONNECT 500
7) Cables are supplied by the meter; length code, refer to the Configuration Manual "General Section for Synchronous
Motors"
8) For 1FT613 motors, the maximum current and rated current of the drive converter must be observed. 1FT616
motors can only be operated together with SIMOVERT MASTERDRIVES MC drive converters.
9) Cable entry 2 x M32 x 1.5
10) Cable entry 2 x M40 x 1.5
11) Cable entry 2 x M50 x 1.5
To Next Page
Loading...
Need help?
General
