Motor Description
Cooling
1FT6 Synchronous Motors
1-28 Configuration Manual, (PFT6), 10.2005 Edition, 6SN1197-0AD02-0BP1
Cooling system
A cooling system (i.e. heat exchanger) must be used in order to guarantee a cooling medium
intake temperature of +30 °C. It is possible to operate several motors from a single cooling
system. The cooling system is not included in the scope of supply.
The cooling power is calculated from the sum of the power losses of the connected motors.
The power of the pump and the distribution to different cooling circuits should be engineered
corresponding to the specified flow and the pressure losses of the individual cooling circuits.
If one pump is used with distribution to several cooling circuits, then it may be necessary to
use a flow controller.
Table 1-12 Addresses of cooling system manufacturers
Name/address Tel./Fax: Internet address / E-mail
Hyfra Industriekühlanlagen
Industriestrasse, 56593 Krunkel
Tel.: +49 (0) 26 87 - 898 0
Fax: +49 (0) 26 87 - 898 25
BKW Kälte–Wärme–Versorgungstechnik
Benzstrasse 2, 72649 Wolfschlungen
Tel.: +49 (0) 70 22 - 50 03 0
Fax: +49 (0) 70 22 - 50 03 30
info@bkw-kuema.de
KKT Kraus Industriekühlung GmbH
Mühllach 131, 90552 Röthenbach
Tel.: +49 (0) 911 - 95333 - 40
Fax: +49 (0) 911 - 95333 - 33
glitschach@kkt-kraus.com
KKW Kulmbacher Klimageräte–Werk GmbH
RIEDEL Kältetechnik Division
Am Goldenen Feld 18, 95326 Kulmbach
Tel.: +49 (0) 9221 - 709 555
Fax: +49 (0) 9221 - 709 549
info@riedel-kkw.de
Helmut Schimpke Industriekühlanlagen
Ginsterweg 25–27, 42781 Haan
Tel.: +49 (0) 2129 - 943 80
Fax: +49 (0) 2129 - 99
Pfannenberg,
Werner-Witt-Straße 121035 Hamburg, Germany
Tel.: +49 (0) 40 - 73412 127
Fax: +49 (0) 40 - 73412 101
www.pfannenberg.de
werner.hille@pfannenberg.com
To Next Page
Loading...
Need help?
General
