Preparing for use
3.2 Transportation and storage
1FK7 G2 synchronous motors
50 Operating Instructions, 05/2021, A5E50907562B AA
Procedure
1. Screw the lifting eyes (eyebolts) in at appropriate locations for the orientation of the motor
during transportation.
2. Hook the beam into the lifting eyes (eyebolts).
Figure 3-2 Transportation with beam
❒
Setting down the motor
Danger of severe injury due to unintentional movements of the motor
If the motor is not secured after being set down, unintentional movements of the motor can
cause serious injury.
• After the motor has been set down, secure it in position.
Do not release the lifting devices until the motor has been secured in position.
Procedure
1. Set the motor down on a hard, level surface.
2. Secure the motor against unintentional movements.
❒
To Next Page
Loading...
