Siemens SIMOTICS S-1FT2 - Document Text Features and Conventions; Third-Party Website Disclaimer

1.2.5 Text features
Description
The chapter describes how text features are marked in this document.
Operating instructions
Handling instructions with a speci󹪝ed sequence start with the word "Procedure":
The individual handling steps are numbered.
1. Execute the operating instructions in the speci󹪝ed sequence.
❒
The square indicates the end of the operating instruction.
Operating instructions without a speci󹪝ed sequence are identi󹪝ed using a bullet point:
• Execute the operating instructions.
Enumerations
• Enumerations are identi󹪝ed by a bullet point without any additional symbols.
– Enumerations at the second level are hyphenated.
Notes
Notes are shown as follows:
Note
A Note is an important item of information about the product, handling of the product or the
relevant section of the document. Notes provide you with help or further suggestions/ideas.
1.2.6 Websites of third-party companies
Description
This document may contain hyperlinks to third-party websites. Siemens is not responsible for
and shall not be liable for these websites and their content. Siemens has no control over the
information which appears on these websites and is not responsible for the content and
information provided there. The user bears the risk for their use.
Introduction
1.2About this manual
SIMOTICS S-1FT2 synchronous motors for SINAMICS S120
10 Operating Instructions, 12/2023, A5E50610821B AF