Siemens SIMOTION D4x5-2 - Page 244

Remember that the 6 CU_Link DOs have to share this one parameter set in the DO CU_I.
1
7KHGHIDXOWLQWHUFRQQHFWLRQVVKRZQJUHHQDUHUHPRYHG
LIWKHXVHULPSOHPHQWVLQWHUFRQQHFWLRQVHJYLD'2
&8B,
'HIDXOW%,&2FRQQHFWLRQ
FDQEHFKDQJHGFRQILJXUHGE\XVHU
,QWHUQDOLQWHUFRQQHFWLRQLQWKH'2&8B,
&8/LQNFRPPXQLFDWLRQFKDQQHO
%,&2FRQQHFWLRQLQWHUFRQQHFWHGE\WKHXVHU
%,&2LQWHUFRQQHFWLRQFDQQRWEHFRQILJXUHG
6,1$0,&6,QWHJUDWHGIURP
6,027,21'[
'HIDXOWZLULQJ
'2&8B&;&;RQ;
/LQH0RGXOHದ
,QIHHGUHDG\
'2&8B&;&;RQ;
/LQH0RGXOHದ
,QIHHGUHDG\
1RWH6LPSOLILHGUHSUHVHQWDWLRQZLWKRQO\
VRPHRIWKHDYDLODEOHSDUDPHWHUV
6,027,21'[
',',
6,027,21&;
',',',
U
U
S>@
U
U
S>@
6,
027,21'[
',',
&;
2QERDUG,2
6,027,21&;
',',
',
U
U
U
'2/LQH0RGXOH
'2/LQH0RGXOH
'2/LQH0RGXOH
'[
2QERDUG,2
'2&8B,
'2&8B/,1.
'2&8B/,1.
U
U
U
U
S>@
S>@
S>@
U
S>@
S>@
S>@
U
U
U
Figure 7-37 Interconnection on the SINAMICS Integrated
Transfer parameters p850x/r851x (DO CU_I)
Parameters
p8500-p8505 and r8510-r8515 of the Control Unit (DO CU_I) are so-called transfer
parameters. This means that a signal, for example, at the binector input p8500[0] is made
available at the binector output p8510[0] and can be interconnected further from there.
Commissioning (software)
7.5 Additional information on configuring the SINAMICS Integrated
SIMOTION D4x5-2
244 Commissioning and Hardware Installation Manual, 03/2018, A5E33441636B