Installing
3.2 Connecting
SINAMICS G120C, FSD ... FSF inverters
40 Compact Operating Instructions, 11/2016, FW V4.7 SP6, A5E39339884B AA
Wiring the terminal strip
Table 3- 8 Permissible cables and wiring options
Solid or finely strand-
ed cable
Flexible conductor
with non-insulated
end sleeve
Flexible conductor
with non-insulated
end sleeve
Two finely stranded cables with
the same cross-section with
partially insulated twin end
sleeves
Wiring the terminal strip to ensure EMC
● If you use shielded cables, then you must connect the shield to the mounting plate of the
control cabinet or with the shield support of the inverter through a good electrical
connection and a large surface area.
● Use the shield connection plate of the inverter as strain relief.
Further information about EMC-compliant wiring is available in the Internet:EMC installation
guideline (http://support.automation.siemens.com/WW/view/en/60612658)
Fieldbus interface allocation
The fieldbus interface is on the underside of the inverter.
GSDML general station description file for PROFINET
The general station description file (GSDML) is an electronic data sheet, which contains all
of the information required for a higher-level control. Using a GSDML, you can configure and
operate a inverter on PROFINET.
GSD Markup Language (GSDML) for PROFINET
Internet: (http://support.automation.siemens.com/WW/view/en/26641490)
Alternative to a download:
The GSDML is saved in the inverter. The inverter writes its GSDML to the inserted memory
card when you set p0804 = 12. For instance, you can transfer the file to a PC from the
memory card.
To Next Page
Loading...
