Siemens SINAMICS G120C - Quick Commissioning with the BOP-2

Commissioning
4.2 Commissioning with BOP-2 operator panel
SINAMICS G120C, FSD ... FSF inverters
Compact Operating Instructions, 11/2016, FW V4.7 SP6, A5E39339884B AA
43
4.2.1
Quick commissioning with the BOP-2
Starting quick commissioning
Preconditions
● The power supply is switched on.
● The operator panel displays setpoints and actual values.
Procedure
Proceed as follows to carry out quick commissioning:
Press the ESC key.
Press one of the arrow keys until the BOP-2 displays the "SETUP" menu.
To start quick commissioning, in the "SETUP" menu, press the OK key.
If you wish to restore all of the parameters to the factory setting before the quick
commissioning, proceed as follows:
1. Press the OK key.
2. Switchover the display using an arrow key: nO → YES
3. Press the OK key.
When you select an application class, the inverter assigns suitable default settings to the
motor control:
● STANDARD
Standard Drive Control (Page 45)
● DYNAMIC
Dynamic Drive Control (Page 47)
● EXPERT
This procedure is described in the operating instructions
Overview of the manuals (Page 86)