Siemens SINAMICS G120D - Settings PROFIBUS DP Address with DIP Switches

Installation
3.7 Settings PROFIBUS DP address with DIP switches
Getting Started
40 Getting Started, FW V4.5, A5E03404762A AB
1RWHV
3LQ /
3LQ /
3LQ /
3LQ 1RWFRQQHFWHG
3LQ 1RWFRQQHFWHG
3LQ 1RWFRQQHFWHG
3( 3URWHFWLYH(DUWK
3LQ 8
3LQ 1RWFRQQHFWHG
3LQ :
3LQ (0%UDNH
3LQ 7HPSHUDWXUHVHQVRU
3LQ (0%UDNH
3LQ 9
3LQ 7HPSHUDWXUHVHQVRU
3( 3URWHFWLYH(DUWK
30'FRQQHFWLRQV
&RQQHFWRUV
0DLQVVXSSO\
0RWRURXWSXW
7\SH+$14PDOH
6SHF$&99s
7\SH+$14IHPDOH
6SHF
,PSRUWDQW7KHFRQQHFWLRQSLQRXWVUHIHUWRWKHDFWXDOFRQQHFWRUVRQWKH3RZHU0RGXOH
Figure 3-18 PM250D connections diagram
3.7 Settings PROFIBUS DP address with DIP switches
Setting the PROFIBUS DP address
Prior to using the PROFIBUS DP interface, the address of the node (Inverter) must be set
using the seven PROFIBUS DP address DIP switches on the Control Unit.
The PROFIBUS DP address can be set between 1 and 125.
Note
The address is taken from P0918 if all PROFIBUS DP address DIP switches are in the OFF
position, otherwise the DIP switch setting is valid.
CAUTION
The external 24 V power supply must be switched off before the DIP switch settings are
changed. DIP switch setting changes do not take effect until the Control Unit has been
powered-up again.