Siemens SINAMICS G120D - Default Chapter; Table of Contents

Getting Started
Getting Started, FW V4.5, A5E03404762A AB
3
Table of contents
1 Safety notes............................................................................................................................................... 5
2 Introduction................................................................................................................................................ 9
2.1 SINAMICS G120D Inv
erter............................................................................................................9
2.2 Commissioning tools....................................................................................................................11
3 Installat
ion ............................................................................................................................................... 13
3.1 General layout SINAMICS G120D
...............................................................................................13
3.2 Fitting the CU to the PM...............................................................................................................15
3.3 Drill pattern SINAMICS G120D
....................................................................................................17
3.4 SINAMICS G120D Electrical data................................................................................................19
3.5 EMC installation guidelines..........................................................................................................21
3.5.1 Connections and interference
suppression .................................................................................21
3.5.2 Basic EMC Rules .........................................................................................................................21
3.5.3 Equipotential bonding G120D-2
...................................................................................................23
3.5.4 Grounding details.........................................................................................................................25
3.6 Connections and cable for
the SINAMICS G120D ......................................................................27
3.7 Settings PROFIBUS DP address with DIP switches ...................................................................40
3.8 Connecting the PROFI
NET interface...........................................................................................41
3.9 Selecting the interface ass
ignments ............................................................................................42
4 Commissioni
ng ........................................................................................................................................ 47
4.1 Default settings for the SINAMICS G120D
..................................................................................47
4.2 Commissioning with the IOP
........................................................................................................47
4.2.1 Basic commissioning with IOP and P0015 Macros
.....................................................................48
4.3 Commissioning the appli
cation ....................................................................................................53
4.4 Reset Parameters to Factory Settings.........................................................................................53
5 Troubleshooting
....................................................................................................................................... 55
5.1 List of alarms and faults ...............................................................................................................55
5.2 Status LED overview....................................................................................................................60
5.3 Further information
.......................................................................................................................62