Installation
3.9 Selecting the interface assignments
Getting Started
42 Getting Started, FW V4.5, A5E03404762A AB
3.9 Selecting the interface assignments
Description
The converter offers different predefined assignments (macros) for its inputs and outputs and
the fieldbus interface.
Only the inputs and outputs whose functions change by selecting a specific assignment, are
shown on the following pages.
Procedure
● Wire up the converter according to the interface assignment most suitable for your
application.
Further steps
● In the basic commissioning, select the default settings of the interfaces that best match
your particular wiring.
● If necessary, after the basic commissioning, adjust the function of the inputs or outputs
and the fieldbus interface.
Fixed speeds
The default "Macro 1" is available only with Control Units CU240D-2 DP and CU240D-2 PN.
212))ULJKW
212))OHIW
$FNQRZOHGJH
)L[HGVSHHG
)L[HGVSHHG
7ZRZLUHFRQWUROZLWKWZRIL[HG
VSHHGV
)DXOW
$ODUP
)L[HGVSHHG
)L[HGVSHHG
',DQG', +,*+
&RQYHUWHUDGGVWRJHWKHU
IL[HGVSHHGIL[HGVSHHG
0DFUR
S
S
;
',
; ',
; ',
; ',
; ',
',
;
;
'2
'2
;
;
$,
; $,
212))IL[HGVSHHG
)L[HGVSHHG
$FNQRZOHGJH
)DXOW
$ODUP
7ZRIL[HGVSHHGVZLWKVDIHW\IXQFWLRQ
5HVHUYHGIRUVDIHW\
IXQFWLRQ
)L[HGVSHHG
)L[HGVSHHG
',DQG', +,*+
0RWRUURWDWHV
ZLWKIL[HGVSHHGIL[HGVSHHG
0DFUR
; ',
; ',
; ',
; ',
; ',
',
;
;
'2
'2
S
S
;
;
$,
; $,
You must enable the safety function.
To Next Page
Loading...
