Siemens SINAMICS G120D - Page 51

Commissioning
4.2 Commissioning with the IOP
Getting Started
Getting Started, FW V4.5, A5E03404762A AB
49
1. Select "Basic Commissioning..." from the Wizards
menu.
:,=$5'6
%DVLF&RPPLVVLRQLQJ
2SHQ/RRS&RPSUHVVRU
&ORVHG/RRS&RPSUHVVRU
5ROOHU&RQYH\RU
2SHQ/RRS)DQ
&ORVHG/RRS)DQ
2SHQ/RRS3XPS
2. Select "Yes" or "No" to a factory reset.
The factory reset is performed prior to saving all the
parameter changes that have been made during the
basic commissioning process.
%DVLF&RPPLVVLRQLQJ
)DFWRU\5HVHW
<HV
1R

3. Select the Control Mode for the attached motor.
%DVLF&RPPLVVLRQLQJ
&RQWURO0RGH
9IZLWK/LQHDU&KDUDFWHULV
9IZLWK)&&
9IZLWK4XDGUDWLF&KDUDFW
9IZLWK3URJUDPPDEOH&KD
9I&RQWUROZLWK/LQHDU&KD

4. Select the correct Motor Data for your Inverter and
attached motor.
This data is used to calulate the correct speed and
displayed values for the application.
%DVLF&RPPLVVLRQLQJ
0RWRU'DWD
(XURSH+]N:
1$PHULFD+]+3
1$PHULFD+]N:

5. Select the correct frequency for your Inverter and
attached motor.
The use of the 87 Hz characteristic allows the motor to
operate at 1.73 times of its normal speed.
%DVLF&RPPLVVLRQLQJ
&KDUDFWHULVWLF
+]
+]
