3.2 Basic parameter configuration regarding SINAMICS V90 PN
Speed control with SINAMICS V90 and S7-300 via Profinet
Entry-ID: 109743898, V1.0, 07/2016
Siemens AG 2016 All rights reserved
2. Here, insert the S7-300 CPU modules to the project directly.
3. Double-click the PLC CPU to enter properties of the CPU in the device
view:
Here, you can configure information about the device name, Ethernet
address…You can also use the “Online access” node to find the
accessible device and make sure the information is consistent:
To Next Page
Loading...
