SINUMERIK 802S base line Control System
1-2
SINUMERIK 802S base line
Start-Up
Software components
The SINUMERIK 802S base line comprises the following software components,
which can be ordered:
z
System software on the permanent flash memory of the CNC
Boot software
loads the remaining system software from the permanent memory
into the user memory (DRAM) and starts the system.
MMC software (Man Machine Communication),
implements all operating functions
NCK software (NC Kernel)
implements all NC functions. This software controls an NC channel
with a maximum of 3 movement axes and a spindle.
PLC software (Programmable Logic Control)
executes the integrated PLC user program cyclically.
Integrated PLC user program
intended to adjust the SINUMERIK 802S base line to the machine
functions (see also Description of Functions “Integrated User
Program for SINUMERIK 802S base line”).
z
Toolbox
WinPCIN transfer program for a PC/PG (programming device) to
transfer user data and programs
Text manager
Cycle kit for loading into the control system using WinPCIN
User program library
Technological machine data files
Programming tool
z
Update diskettes
Update program with operator prompting system
802S base line system software, packed, for loading and programming
the SINUMERIK 802S base line via an update program.
User data
User data are:
z
Machine data
z
Setting data
z
Tool data
z
R parameters
z
Zero offsets
z
Compensation data
z
Part programs
z
Standard cycles
Data saving
Modified user data are saved for at least 50 h after power off or power failure.
After then, they might get lost.
Warning
To avoid data loss, the operator must carry out data saving (see Section 4.1.4).
!
To Next Page
Loading...
Need help?
General
