Start-Up
4-42
SINUMERIK 802S base line
Start-Up
In practice, this value can be optimized. To this aim, the thread is first tested
with compensating chuck and the calculated values. Then the values should be
modified sensitively such that the difference path in the compensating chuck
approximates to zero.
Now, the POSCTRL_GAIN values displayed on the service display for axis and
spindle should be identical.
Notice
If MD 32900 DYN_MATCH_ENABLE has been set to “1” for the drilling axis,
it should also be set to “1” for all interpolating axes. This increases the
traversing accuracy along the contour. However, the entries for these axes in
MD 32910 DYN_MATCH_TIME [n] must be left at the value “0”.
Backlash compensation
Overview
The falsification of axis travel due to mechanical backlash can be compensated
(cf. Technical Manual “Description of Functions”).
Function
The axis-specific actual value is corrected by the backlash compensation value
(MD32450 BACKLASH) with each change of the traversing direction.
Activation
The backlash compensation is active in all operating modes only after referencing.
Notice
Which step size is added to the backlash compensation value is determined by
MD36500 ENC_CHANGE_TOL.
Leadscrew error compensation (LEC)
Overview
The compensation values are determined by means of the measured error
curve and entered in the control system using special system variables during
start–up. The compensation tables (cf. Technical Manual “Description of
Functions”) must be created in the form of NC programs.
Function
The leadscrew error compensation (LEC) changes the axis–specific actual
position by the associated compensation value.
If the compensation values are too high, an alarm message can be output (e.g.
contour monitoring, speed setpoint limitation).
Activation
The LEC is only activated in all operating modes if the following requirements
are met:
z
The number of compensation intermediate points must be defined. They
are only active after Power ON (MD: MM_ENC_MAX_POINTS).
To Next Page
Loading...
