Siemens SINUMERIK 808D ADVANCED

808D ADVANCED Page 91 Programming and Operating — Turning
Sample
Programs
s
Content
DRAWING
Unit Description
This unit shows three typical program examples of frequently used turning
cycles and the corresponding machining diagrams with detailed explana-
tions.
Unit Content
Turning
program 1
Turning
program 2
Turning
program 1
Tool information：
T1 Turning tool D0.8
T2 Turning tool D0.8
Actual effect
Turning
program 3
Note: All the program examples in this book are only for reference.
If you want to perform actual operations, please adjust the tool
offset, coordinate moving range, workpiece plane settings, etc.
according to the actual machine conditions!
End
Make make sure all the preparations and
safety measures have been performed
before machining！
Turning
program 4