Programming principles
1.12 Timers and workpiece counters
Turning Part 2: Programming (Siemens instructions)
102 Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0
Display
The contents of the active system variables are visible on the screen under <OFFSET> ->
"Sett. data" >"Time counter":
Total parts= $AC_TOTAL_PARTS
Required parts= $AC_REQUIRED_PARTS
Number of parts =$AC_ACTUAL_PARTS, $AC_SPECIAL_PARTS not available for display
"Number of parts" is also visible in the AUTOMATIC mode in the "Machine" operating area in
the information line.
To Next Page
Loading...
