Cycles
2.6 Error messages and error handling
Turning Part 2: Programming (Siemens instructions)
196 Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0
2.6.4 Messages in the cycles
The cycles display their messages in the message line of the control system. These
messages will not interrupt the program execution.
Messages provide information with regard to a certain behavior of the cycles and with regard
to the progress of machining and are usually kept beyond a machining step or until the end
of the cycle. An example of messages is as follows:
"Depth: according to the value for the relative depth" from all drilling cycles.
To Next Page
Loading...
