Cycles
2.1 Overview of cycles
Turning Part 2: Programming (Siemens instructions)
104 Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0
Example
To call a cycle, follow these steps:
1. In the program editor window, position your cursor to the desired line to insert a cycle.
Press "Turn." and select your desired cycle type, for example "Stock removal".
2. The CYCLE 95 window opens. Enter the value for each parameter and confirm your
input by pressing "OK".
3. After completion, the final result appears in the editor window.
To Next Page
Loading...
Need help?
General
