Siemens SINUMERIK 808D

Table of contents
Turning Part 2: Programming (Siemens instructions)
Programming and Operating Manual, 05/2012, 6FC5398-5DP10-0BA0
5
2.5.1 Requirements.............................................................................................................................144
2.5.2 Cutoff - CYCLE92 ......................................................................................................................
146
2.5.3 Groove - CYCLE93 ....................................................................................................................
148
2.5.4 Undercut (forms E and F to DIN) - CYCLE94............................................................................
157
2.5.5 Cutting with relief cut - CYCLE95 ..............................................................................................
161
2.5.6 Thread undercut - CYCLE96 .....................................................................................................
177
2.5.7 Thread chaining - CYCLE98......................................................................................................
181
2.5.8 Thread cutting - CYCLE99.........................................................................................................
187
2.6 Error messages and error handling ...........................................................................................
195
2.6.1 General Information ...................................................................................................................
195
2.6.2 Error handling in the cycles........................................................................................................
195
2.6.3 Overview of cycle alarms ...........................................................................................................
195
2.6.4 Messages in the cycles..............................................................................................................
196
3 Typical turning program.........................................................................................................................
197
Index......................................................................................................................................................
207