Siemens Sinumerik 810T - Alphabetical List of Terms and Sections

01.93 8 Appendix
8.2 List of terms used
8.2 List of terms used
Term Section
Acknowledge alarm 2.1.1.5
Acknowledge messages 4.6
Actual position 2.1.1.5
Actual value setting 2.3.2
Actual value setting (Preset) 3.2.7
ADD.FUNCT. 2.5
Address/numerical keys 2.1.1.3
Alarm acknowledge 2.1.1.5
Alarm messages 4.6
AUTOMATIC 3.2.2
AUTOM. TO 2.5
AUTOM. TOOL COMP 2.5
AUTOM. ZO 2.5
AUTOM. ZERO POINT 2.5
Axis synchronization 3.1.8
Basic dimension 3.1.4
BLOCK end 2.5
BLOCK number 2.5
BLOCK search 2.5
Block search 3.2.3.3
Block transfer 3.1.15.4
BTR START 2.5
Buffer batteries 5.2
Channel switchover 2.1.1.5
CIRCLE 2.5
Cleaning 5.3
CLEAR PRE-OFF 2.5
CONTOUR 2.5
Contour 3.1.11
Control keys 2.1.1.5
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 8-3
SINUMERIK 810T, GA3 (BN)