Siemens Sinumerik 810T - Page 306

09.91 8 Appendix
8.2 List of terms used
Term Section
EMERGENCY STOP 2.5
ENABLE 2.5
Enable 3.2.9/3.2.10
ERASE 2.5
Erase 3.1.14
EXT START 2.5
External machine control panel 2.1.2/2.1.2.1
FEED 2.5
Feed 2.1.1.6
”Feed hold” display 2.1.1.2
Feed/jog 2.3.2
Feed/rapid override 2.1.2.1
Feed stop/feed start 2.1.1.6/2.1.2.1
Flexible plane selection 3.1.7
G FUNCTIONS 2.5
GUIDING 2.5
HANDWHEEL 2.5
Handwheel 3.2.9
”Incremental” (INC...) mode 3.2.8
Incremental Jog 1... 10 000 2.3.2
Input character/word 2.1.1.4
Input with operator guiding 3.1.7.2
Installation 2.1.1.5
Interfaces 6
Integrated machine control panel 2.1.1.6
Integrated tool management 3.1.4.5
”Jog” (JOG) mode 3.2.7
Key assignment (LED) display 2.1.1.2
Keyswitch 2.1.2.1
LIST OF TOOLS 2.5
Machine data 7.3
© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 8-5
SINUMERIK 810T, GA3 (BN)