EasyManuals Logo

Siemens SINUMERIK 840C User Manual

Siemens SINUMERIK 840C
291 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #129 background imageLoading...
Page #129 background image
5 Measuring Cycles for Milling Machines and Machining Centres 07.90
5.1.3 L976 Calibrating workpiece probe in any hole (plane)
Example: Calibrating workpiece probe 3 in the X-Y plane
The probe length (Z axis) must have been input in the TO memory prior to cycle call, e.g. D98
(in this case value 50).
%MPF 9764
N1 T200 T No. probe
N5 G59 X100 Y50 Z0 Load ZO values
N10 G54 G17 G00 X100 Y80 Probe at centre point and
ZO selection
N15 D98 Z10 Selection of length compensation
Position probe in hole
N20 R22=3 R23=2 R25=0 R27=1 Parameters for calibrating cycle
R28=1 R32=100 R33=0 R36=1
N25 L976 Cycle call for calibrating in the
X-Y-plane
N20 M30
The new trigger values are stored in the relevant MDC areas.
5–10 ©
Siemens AG 1990 All Rights Reserved 6FC5197- AB70
SINUMERIK 840/850/880 (BN)

Table of Contents

Other manuals for Siemens SINUMERIK 840C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840C and is the answer not in the manual?

Siemens SINUMERIK 840C Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 840C
CategoryControl Unit
LanguageEnglish

Related product manuals