07.90 5 Measuring Cycles for Milling Machines and Machining Centres
5.2.2 L977 Measure shaft (paraxial)
Example: Measure shaft with measuring cycle L977
(Data as in Fig. 5.10)
%MPF 9773
:
Machining program
:
N500 G54 T200 T No. probe; select ZO
N505 G00 X180 Y130 Position probe in X and Y axes at
shaft centre point
N510 Z101 D99 Position Z axis above shaft
N515 R10=2030 R11=10 R19=-30 R22=1 Define parameters for measuring cycle
R23=2 R25=0 R27= 1 R28=1
R29=3 R33=0.002 R34= 0.03 R36=1
R37=0.06 R40=0.03 R41=-0.03 R42=130
N530 L977 Cycle call for shaft measurement
in X/Y
N535 G00 Z160 Run up Z axis
N540 M30
© Siemens AG 1990 All Rights Reserved 6FC5197- AB70 5–21
SINUMERIK 840/850/880 (BN)
To Next Page
Loading...
Need help?
General
