07.90 5 Measuring Cycles for Milling Machines and Machining Centres
5.2.4 L977 Measure web (paraxial)
Example: Measure web with measuring cycle L977
(Data as in Fig. 5.12)
%MPF 9775
:
Machining program
:
N500 G54 T200 T number probe; select ZO
N505 G00 X220 Y130 Position probe in X axis above
slot centre point and in the
Y axis at measuring position
N510 Z101 D99 Position Z axis above web
N515 R10=2030 R11=10 R19=-40 R22= 1 Define parameters for measuring
cycles
R23=12 R25=0 R27= 1 R28= 1
R29=3 R30=1 R33= 0.002 R34= 0.03
R36=1 R37=0.06 R40= 0.03 R41=-0.03
R42=60
N525 L977 Cycle call for web measurement
in X direction
N530 G00 Z160 Run up Z axis
N535 M30
© Siemens AG 1990 All Rights Reserved 6FC5197- AB70 5–29
SINUMERIK 840/850/880 (BN)
To Next Page
Loading...
Need help?
General
